Write Configuration to Serial Port Command (Configure Menu)

This writes the configuration data, for the circuit being displayed, to the evaluation board’s microprocessor which in turn writes the configuration data to the Field Programmable Analog Array chip. The PC serial port should be connected to the evaluation board. The data is transmitted from the PC to the evaluation board via the serial port.

As soon as the data has been successfully transmitted, the chip will begin functioning as the circuit that you downloaded. You will be able to see the results on your oscilloscope immediately.

If you experience difficulties with serial download, see the Serial Port Communications Problems section in the help system..

Shortcuts

Toolbar:

Mouse:Right-Click Context Menu

Keys:CTRL+W